Secondary Remotes

In addition to a Master Remote any DX system can also have a Secondary Remote installed. This enables the user to have a wider choice of input or specialised rehab controls.

DX-ACU1 Attendant Dual Control

---

Joystick remote that enables an attendant to drive the chair instead of the user. The attendant dual control unit may be used in addition to a secondary remote and master remote all on the same system.

• Switchable control between Attendant and User
• Independent speed control

Part Numbers

• DX-ACU1 Attendant Dual Control

also required – DX BUS cable

DX-RJM Remote Joystick Module

Standard proportional joystick for mounting in a range of positions, e.g. chin control, mid line.

Part Numbers

• DX-RJM Remote Joystick Module

DX-RJM-HD Heavy Duty Joystick

---

Heavy duty switched joystick remote for users who might damage a standard joystick through rough handling.

• Designed for robustness using heavyduty switches
• 8 driving directions

Part Numbers

• DX-RJM-HD Heavy Duty Switch Joystick

also required – DX BUS cable

DX-RJM-MINI Mini Joystick

Very low force proportional joystick secondary remote offering comparable performance to a conventional joystick.

• Sealed unit, suitable for tongue, finger, thumb, hand, chin control
• Light touch, low deflection operation(<10 grams)
• Fully proportional control
• Ergonomic shape ideal for thumb control
• Fully sealed unit

Part Numbers

• DX-RJM-MINI Mini Joystick

Includes a mounting kit, alternative cork ball knob and interface box for connection to the power module. Requires switch for drive profile.

DX-RJM-VIC-CCD Finger Steering Control

Non contact proportional finger control for use by users with limited finger strength.

• Designed for finger control with zero force required
• Full proportional control with no physical contact
• Any angle mounting

Please note addtional protection is required if driving outdoors in wet conditions.

Part Numbers

• DX-RJM-VIC-CCD Finger Steering Control

DX-ACC4B Switch Interface

Input module for up to 5 switches.

• 9 pin D-type connector
• Ideal for use with 3-quadrant and 4-quadrant switched head controls
• Simple driving interface with up to 8 driving directions
• Provides power to active switch controls

Part Numbers

• DX-ACC4B Switch Interface

also required – DX BUS cable, switches

DX-SNP Sip and Puff Interface

Sip and Puff control that can be fine tuned to suit any user or application.

• Fully programmable sip and puff pressures
• 7 standard drive programs
• Latched driving (step or progressive step) with optimised safety through programmable emergency stop and latched time options
• Easy custom programming using DX Hand Held Programmer
• Optimum safety through programmable Emergency Stop and Latch Time options
• Mode Control feature

Part Numbers

• DX-SNP Sip and Puff Module

also required

• DX BUS cable
• GSM9977 Sip and Puff Mounting Kit
• GSM9942 SNP Filter
• SW932662 Set of 10 straws
• SWTA5100 SNP breath operated mode switch

GSM9977 Sip & Puff Mounting Kit

---

A complete set of parts required to operate the Sip and Puff module. Contains:

• 21 inch gooseneck
• Air Tube Straws x 2
• Tubing x 1m
• Wheelchair clamp
• Saliva trap

Part Numbers

• GSM9977 Sip and Puff Mounting Kit